1
This 845-page Delta Electronics manual (version 2.2.0, 30 October 2026) is the instruction reference for motion control programming on the AX series, written for use with DIADesigner-AX. It covers three chapters; here is what each one contains. For hardware and project set-up, see our DIAInstaller guide and the AX-308E CODESYS-based motion controller article.
Chapter 1 – Introduction to motion control
- Basics of motion control instructions and user unit configuration.
- Descriptions of the motion control instructions and an overview of the Delta motion instructions library versions.
- Device categories and PDO mapping.
- Hardware limit reverse movement function (new): functional workflow and parameter settings.
Chapter 2 – Motion control instructions
- SM3 Basic – motion control and administrative instructions.
- DL_MotionControl and DL_MotionControlLight – Delta motion libraries, including positioning axis, velocity axis and tension control instructions.
- DL_ServoPress_AX – servo press instruction.
- DL_PLCopenPart3 – PLCopen Part 3 motion and administrative instructions.
- DL_RotaryCut – rotary cutting instructions.
- Tension control – servo configuration, closed-loop speed control and diameter calculation (INT and SR versions).
Chapter 3 – Appendix
- Instruction tables and indexes: by function, by device and alphabetical.
- Data types: enumerations and structures.
- Error codes and troubleshooting for synchronous axes, positioning axes and the SM3_Drive_ETC library (for EtherCAT drives).
- Explanation of DMC_Home_P.
What is new in version 2.2.0
- Hardware limit reverse movement function added in Section 1.6, with its workflow and parameters.
